Symbol Technologies AP-5131 - Manual (Page 549)

AP-5131 Usage Scenarios B-3
e. Add the following 3 new options under AP5131 Options class:
f. Highlight Scope Options from the tree and select Configure Options .
g. Go to the Advanced tab. From under the Vendor Class AP5131 Options, check all three
options mentioned in the table above and enter a value for each option.
3. Copy the firmware and configuration files to the appropriate directory on the TFTP Server.
By default, auto update is enabled on the AP-5131 (since the LAN Port is a DHCP Client,
out-of-the-box auto update support is on the LAN Port).
4. Restart the AP-5131.
5. While the AP-5131 boots, verify the AP-5131:
• Obtains and applies the expected IP Address from the DHCP Server
• Downloads both the firmware and configuration files from the TFTP Server and updates
both as needed. Verify the file versions at the AP-5131’s System Settings screen.
Code Data type
AP-5131 TFTP Server IP Address
(Note: Use any one option) 181
186 IP address
String
AP-5131 Firmware File Name 187 String
AP5131 Config File Name
(Note: Use any one option) 129
188 String
String
NOTE If the firmware files are the same, the firmware will not get updated. If
the configuration file name matches the last saved configuration file on
the AP-5131, the configuration will not get updated.