Schumacher SI263 - Manual (Page 21)

To set battery type to one of the following two selections, press
the BATTERY TYPE button.
• 12 Volt: Battery typically used in cars, trucks and motorcycles.
These batteries usually have vent caps and are often marked
“low maintenance” or “maintenance-free.”
• 6 Volt: Battery typically used in antique and some specialized
vehicles.
Automatic Shut Off: When the 2A, 4A or 6A charge rate is
selected, the Battery Manager is set to perform an automatic
charge. The charging process stops automatically after the battery
is charged.
Aborted Charge: If the charging process cannot be completed
normally, charging is aborted. The Battery Manager’s output is
shut off and the CHECK (red) LED blinks. In this state, the Bat-
tery Manager’s buttons are inoperative. To reset after an aborted
charge, unplug the Battery Manager and plug it in again.
Charging Complete: The CHARGED (green) LED illuminates
when charging is complete. The Battery Manager stops charging
and switches automatically to Maintain Mode.
Battery Type Button
21 21
SI263 IM 0205v1.indd 21 3/2/05 4:41:08 PM