Sony CHC-TB20 - Manual (Page 12)

12 GB
Labeling a CD (continued)
5
Press . or > on the remote to
select the desired character.
You can also select the following symbols.
’ – / , . ( ) : ! ? & + < > _ = ” ; # $ % @ `
To enter a blank space
Press M on the remote.
6
Press M on the remote.
The character you selected in step 5 stops
flashing and the cursor shifts to the right.
7
Repeat steps 4 to 6 to complete the
entire title.
8
Press ENTER/YES to complete the
labeling procedure.
If you make a mistake
During step 4 to 6, press m or M on the
remote until the character you want to change
flashes, then repeat steps 4 to 6.
To erase a character
During step 4 to 6, press m or M on the
remote until the cursor shifts to the character
you want to erase, then press CLEAR on the
remote while the character is flashing. You
cannot insert characters.
To cancel labeling
Press MENU/NO on the remote.
Checking the disc titles
1
Press FUNCTION repeatedly to switch the
function to CD.
2 Press DISC SKIP on the remote repeatedly
until the desired CD appears.
3 Press MENU/NO on the remote in stop
mode.
4
Press . or > on the remote until
“Name Check?” appears, then press
ENTER/YES on the remote.
5 Press . or > on the remote to select
the disc titles stored in the system memory
between 01 and 50.
To check the current disc title
Press SCROLL on the remote in stop mode.