Samsung SCX-RD100 - Manual (Page 16)

16 – COAXIAL REMOTE CONTROLLER
Connection & Control
TO CONTROL THE CAMERA USING RS-485 SIGNAL
OUTPUT VIA RS-232 COMMUNICATIONS
Connect the product to DC 12V power source or insert 4 AA-sized
batteries into the battery compartment.
Set the protocol switch 8 to ON.
Connect the RX(+/-) of the unit to the RS-485(+/-) port of the camera.
Match the camera’s address, baud rate, and protocol to the same to
those of the unit.
RS-232 can be controlled using the Samsung protocol alone.
Connect the RS-232 device’s cable to the RS-232 port of the main unit.
Using RS-232 device, you can control the camera menu.
1.
2.
3.
4.
–
5.
6.
ADDRESS (X)100 (X)10 (X)1
POWER
OFF ON
CABLE COMPENSATION
S L
REMOTE CONTROLLER SCX-RD100
POWER STATUS
TERMINATION PROTOCOL
1 ON 2345678 1 ON 2
RS-232 and RS-485 communications cannot be used for simultaneous input.
For the switch settings, see the switch setting table. (See page 17)
Input of video signal is required to control RS-485.
ƒ
ƒ
ƒ
NOTE
S
N
❖
❖
N