Sharp PGD210U - Manual (Page 22)

E-21
Basic Operation of the Projector
1 1. Connect the AC cord
Connect the supplied AC cord to the AC inlet on
the back of the projector.
OFF ON
110-120V/
200-240V~
1 AC cord
2 2. Turn on the MAIN POWER
Press the MAIN POWER switch on the back of the
projector. The POWER indicator lights red and the
projector enters STANDBY mode. ON OFF
P O W E R L A M P T E M P .
When the MAIN
POWER is on, the
POWER indicator
lights red.
Projector
ON/OFF
Remote control
ON/OFF
ON
OFF
3
P O W E R L A M P T E M P .
When the power is on, the LAMP
REPLACEMENT indicator flashes
to show the operating condition of
the lamp.
Green: Lamp is ready
Flashing green: Warming up
Red: Change bulb
3. Turn on the POWER
Press the POWER ON/OFF button on the projector or the
POWER ON button on the remote control.
• When the power is turned off by pressing the POWER
ON/OFF button, the POWER indicator will not turn off
until the fan has stopped running.
• See page 30, “Lamp/Maintenance Indicators” for
details.
Notes:
• When the POWER indicator is not lit, the remote control cannot be
used to operate the projector.
• The flashing green LAMP REPLACEMENT indicator indicates that the
lamp is warming up. Wait until the indicator stops flashing before
operating the projector.
• If the power is turned on immediately after it has been turned off, it
may take a short while before the lamp turns on. (During this period
the LAMP REPLACEMENT indicator flashes.)
• After the projector is unpacked and turned on for the first time, a
slight odor may be emitted from the exhaust fan. This odor will soon
disappear with use.
Caution:
• Be sure to take off the lens cap before operation of the projector. Do
not place the lens cap on the lens during operation. The lens cap
may become extremely hot.