Sony DAV-HDX475 - Manual (Page 80)

80 GB
To enjoy the same function as the unit,
select “MAIN UNIT.”
When “TUNER FM” or “TUNER AM” is
selected on the unit, you can only select the
same band for the tuner on the S-AIR
receiver. In this case, when you select other
than “TUNER FM” or “TUNER AM” on
the unit, you can select any band for the
tuner on the S-AIR receiver.
4
Adjust the volume on the S-AIR
receiver.
Note
• When the sound is other than 2 channel stereo, multi
channel sound is downmixed to 2 channel.
• The sound of the S-AIR receiver may be cut off by
operation of the unit.
To control the system from the
S-AIR receiver
You can control the system from the S-AIR
receiver by using the following buttons.
For details, refer to the operating instructions of
the S-AIR receiver.
You can enjoy the S-AIR receiver while the unit
is in standby mode by setting “S-AIR STBY” to
“ON.”
1
Press SYSTEM MENU.
2
Press X/x repeatedly until “S-AIR
STBY” appears in the front panel
display, then press
or c.
3
Press X/x to select the desired setting.
• “ON”: You can enjoy the S-AIR receiver
while the unit is in standby mode or turned
on.
• “OFF”: You cannot enjoy the S-AIR
receiver while the unit is in standby mode.
The default setting differs depending on the
model.
4
Press .
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
Note
• When you set “S-AIR STBY” to “ON,” the power
consumption during the standby mode increases.
• When you turn the system off while “S-AIR STBY”
is set to “ON,” “S-AIR” flashes (when sound
transmission between the unit and S-AIR receiver is
not established), or lights up (when sound
transmission between the unit and S-AIR receiver is
established) in the front panel display.
• If you turn the system off with the disc tray opened
while “S-AIR STBY” is set to “ON,” the disc tray
may not close automatically.
• When the wireless transmitter is not inserted in the
unit, you cannot set “S-AIR STBY.”
• “S-AIR STBY” is set to “OFF” automatically when
the wireless transmitter is removed from the unit.
It is easy to set the same ID for the unit and an
S-AIR sub unit, such as a surround amplifier or
S-AIR receiver, to establish sound transmission.
However, neighbors may also receive your
system’s sound if IDs are the same, or you may
receive the sound from neighbors. To prevent
this, you can identify the unit with a specific
S-AIR sub unit by performing the pairing
operation.
When you perform pairing
Before pairing, sound transmission is
established by the ID (example).
Press Operation
H, X, x,
./> Share the same operations on the
remote and unit.
S-AIR CH Change the function of the system.
Enjoying the S-AIR receiver
while the unit is in standby
mode
For the S-AIR receiver
Identifying the unit with a
specific S-AIR sub unit
(Pairing operation)
For the surround amplifier
For the S-AIR receiver