Sony DVP-FX1021 - Manual (Page 23)

Intr
oductions
23
Power Connections (continued)
A Charging the battery pack
1. Attach the battery pack to the player.
2. Connect the AC power adaptor to the player and
then plug into an AC outlet.
When charging starts, “ ” appears on the
display window.
3. Disconnect the AC power adaptor from the player
and pull out the plug from the AC outlet after
charging.
When charging is complete, “
” appears on
the display window.
A Confirm the battery charge on the unit’s display
window
• If using the AC adaptor, battery display does not
appear.
A Recharging and play times
* When Brightness control is set to “ b ”(minimum).
- using the headphones.
- at room temperature (25°C)
NOTES:
• Recharging times shown above depend on operating
conditions.
• When the power is ON, you cannot charge the
battery.
• Charge the battery at a temperature of +5°C (+41°F)
to +35°C (+95°F).
The charging time may vary, depending on the
surrounding temperature.
• The battery will not be charged when it is naturally or
purposely discharged. Because the unit cannot
perceive battery voltage, even if you attached the
battery.
When you are in this situation, power on the unit and
then power off again. Then battery charging will
proceed.
V O L U M E P H O N E S P H O N E S A U D I O V I D E O LINE SELECT
IN OUT
POWER /HOLD
Player
AC adaptor cord insert
jack (DC IN 9.8V)
Recharging Play time (DVD-VIDEO)
with player LCD On
Approx. Approx.
4.8 hours 7 hours*
Full Low
Recharge
Charge indicator
Battery Pack