59 and 60, Troubleshooting (continued) – Sharp XR-10S User Manual

Page 64

Advertising
background image

60

Problem

Picture is green on

INPUT 1 (COMPONENT)/
INPUT 2 (COMPONENT).

Picture is pink (no green)

on INPUT 1 (RGB)/INPUT

2 (RGB).

Picture is too bright and

whitish.

The cooling fan becomes

noisy.

The lamp does not light

up even after the

projector turns on.

The lamp suddenly turns

off during projection.

The image sometimes

flickers.

The lamp needs much

time to turn on.

Picture is dark.

Check

• Change the input signal type setting.
• When you cannot select an input signal type, select “Color is faded

or poor” in the “Help” menu, after selecting an item other than
“sRGB” in “Picture Mode”, and then select an input signal type.

• Image adjustments are incorrectly set.

• When temperature inside the projector increases, the cooling fan

runs faster.

• The lamp indicator is illuminating in red.

Replace the lamp.

• Cables incorrectly connected to the projector or the connected

equipment works improperly.

• Select “Vertical stripes or flickering image appear” in the “Help”

menu and make the necessary adjustments.

• If this happens frequently, replace the lamp.

• The lamp will eventually need to be changed.

While the remaining lamp life draws to a close, replace the lamp.

Page

46
39, 46

40

48, 51

23–26

46

51

51

This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation
or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.

Troubleshooting (Continued)

Advertising
This manual is related to the following products: