Sony DAV-DZ730 - Manual (Page 31)

31 GB
Ge
tting Star
te
d
• [OFF]: The Control for HDMI function is
set to off.
• [ON]: The Control for HDMI function is
set to on.
9
Press C/c to select the speaker
formation image as the speakers are
actually positioned, then press
.
• [STANDARD]: Select this when you
install all the speakers normally.
• [NO CENTER]: Select this when you
install the front and surround speakers
only.
• [NO SURROUND]: Select this when you
install the center and front speakers only.
• [FRONT ONLY]: Select this when you
install the front speakers only.
• [ALL FRONT]: Select this when you
install all the speakers in front of the
listening position.
• [ALL FRONT - NO CENTER]: Select
this when you install the front and
surround speakers in front of the listening
position.
10
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
11
Press C/c to select [YES], then press
.
Be quiet during the measurement.
Note
• Loud test sounds are output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
• The environment of the room in which the
system is installed may affect measurements.
When the measurements differ considerably
from the status of the speaker installation,
perform the speaker settings manually by
following “Settings for the speakers” (page 67).
12
Unplug the calibration mic, press C/c
to select [YES], then press .
To quit the Quick Setup
Press DISPLAY in any Step.
SPEAKER FORMATION
STANDARD
Calibration mic