Troubleshooting – Sony DAV-DZ730 User Manual

Page 71

Advertising
background image

A

d

ditio

n

al Inf

o

rm

at

ion

71

GB

Troubleshooting

If you experience any of the following difficulties while using the system, use this troubleshooting
guide to help remedy the problem before requesting repairs. Should any problem persist, consult your
nearest Sony dealer.
Note that if service personnel changes some parts during repair, these parts may be retained.
When you install the S-AIR sub unit (not supplied), in the event of a problem with the S-AIR function,
have a Sony dealer check the entire system together (main unit and S-AIR sub unit). (DAV-DZ730
only)

General

Picture

Symptom

Problems and solutions

The power is not turned on.

• Check that the AC power cord (mains lead) is connected securely.

The remote does not function.

• The distance between the remote and the unit is too far.

• The batteries in the remote are weak.

The system does not work
normally.

• Disconnect the AC power cord (mains lead) from the wall outlet (mains), then

reconnect after several minutes.

• Perform the following procedure. (Note that the system parameters, such as

preset stations, return to the default settings.)

1

Press "/1 to turn on the system.

2

Press N, FUNCTION, and "/1 on the unit at the same time. “COLD
RESET” appears in the front panel display.

After performing [AUTO
CALIBRATION], [NONE]
appears in the [Measurement
Complete.] display.

• Check the speaker connection (page 25).

• Do not install the speaker in another room.

Symptom

Problems and solutions

There is no picture.

• The video input on your TV is not set so that you can view pictures from the

system.

• Check the output method on your system.

There is no picture when you
make an HDMI cable
connection.

• The unit is connected to an input device that is not HDCP (High-bandwidth

Digital Content Protection) compliant (“HDMI” on the front panel does not
light up).

• If the HDMI OUT jack is used for video output, change the type of video signal

output from the HDMI OUT jack (page 63).
Connect your TV and the unit using a video jack other than HDMI OUT, and
switch your TV’s input to the connected video input so that you can see the on-
screen displays. Change the type of video signal output from the HDMI OUT
jack, and switch your TV’s input back to HDMI. If the picture still does not
appear, repeat the Steps and try other options.

Picture noise appears.

• If the signal from the EURO AV T OUTPUT (TO TV) jack is distorted,

change the type of video signal output from the HDMI OUT jack by setting
[HDMI RESOLUTION] in [HDMI SETUP] to [720 × 480p]

*

(page 63).

* Depending on the area, [720 × 480/576p] may appear.

An image is not displayed on the
entire TV screen.

• Check the setting of [TV TYPE] in [VIDEO SETUP] (page 63).

• The aspect ratio on the disc is fixed.

Advertising
This manual is related to the following products: