Standard Horizon QUEST+ GX1256S - Manual (Page 50)

GX1256S Page 50
8.6 TIME OFFSET
Sets the time difference between local time and UTC (Universal Time Coor-
dinated or GMT Greenwich Mean Time). Time is displayed if the QUEST+ is
connected to a GPS receiver.
1. Press and hold down the [CALL/SET(MENU)] key until
“RADIO SETUP” appears.
2. Press the [CALL/SET(MENU)] key, then press the
[DOWN] key to select “TIME.”
3. Press the [CALL/SET(MENU)] key to enable adjusting
this item (The number in the display will flash).
4. Press the [UP] or [DOWN] key to select “Time Offset”
from UTC. Be sure that when selecting the offset that
the display shows “TIME –” for negative offset, or
“TIME +” for a positive offset. Refer to Offset Time Table.
See illustration below to find your offset time from UTC.
If 0:0 is assigned, the time is the same as UTC.
6. Press the [CALL/SET(MENU)] key to store the time off-
set.
7. Press the [DOWN] key to select “EXIT,” then press the
[CALL/SET(MENU)] key.
8. Press the [DOWN] key to select “EXIT,” then press the [CALL/
SET(MENU)] key to return to the normal operation.
NOTE
During Daylight Saving time subtract 1 hour from the offset shown above
and enter this offset in step 4 above.
OFFSET TIME TABLE