Rear panel, Transducer, Connections – Sound Performance Lab Model 2601 User Manual

Page 12: Mic level output, Line output 1, Line output 2, Pre simulator out

Advertising
background image

12

Transducer

Mic Level Output

The microphone level output is usable just like any mike out. The Miking Level control on
the Transducer front panel regulates the signal. The Output Gain control has no infl uence on
the Miking Level output. Just as with conventional cabinet miking, variations in microphone
preamp choices may of course be made to infl uence further the sonic result.

Balanced XLR output, wiring: pin 1 = ground, pin 2 = hot (+), pin 3 = cold (-).

Line Output 1

The front panel Output Gain control regulates the output signal, which appears at the Line
Output 1 connector.

Balanced XLR output, line signal with +4dB.

Wiring: pin 1=ground, pin 2=hot (+), pin 3=cold (-).

Line Output 2

The front panel Output Gain control regulates the output signal, which appears at the Line
Output 2 connectors.

Balanced XLR and 1/4” TRS connector, line signal with +4dB.
Wiring XLR: pin 1 = ground, pin 2 = hot (+), pin 3 = cold (-).
Wiring TRS: tip =hot (+), ring = cold (-), sleeve = ground.

The Line Output 2 phase switch provides for a reversal of this output‘s signal phase.

IMPORTANT ADVICE

Use only one (either an XLR or 1/4" TRS) Line Output 2 connection at a time. Using both
output connections simultaneously can impair the signal through impedance mismatches
from the doubled load that can lead to such problems as high frequency damping.

However, Line Output 1 and 2 can be used simultaneously.

Pre Simulator Out

This output is independent from Speaker Simulation and thus independent from Transducer
adjustments. The signal at this Pre Simulator Out is that of the power-reduced amp signal (line
level). With this arrangement you can feed a separate amp and guitar box setup or effects
machines.

Connector variant and connections correspond to industry standards: Unbalanced 1/4" Jack
connector with the signal at tip and ground at sleeve.

Mic Level Output, Line Output 1, Line Output 2 (XLR or TRS connection) und Pre Simulator Out
may all be used simultaneously.

Rear Panel

Connections

.*$-&7&-065165

.*$-&7&-

065165

0VUQVU(BJOEPFTOPUBGGFDUUIJTPVUQVU

#BM.JD-FWFM0VUQVU

(/%  °

$POOFDUUPNJDQSFBNQMJGJFS

0VUQVU(BJOEPFTOPUBGGFDUUIJTPVUQVU

#BM.JD-FW

FM0VUQVU

(/%  °

$POOFDUUPNJDQSFBNQMJGJFS

-*/&065165



-*/&065165

1IBTF

3FWFSTF

/PSNBM

1IBTF

3FW

FSTF

/PSNBM

#BMBODFE-JOF-FWFM0VUQVUT

9-3(/%  °

+BDL5JQ 3JOH ° 4MFFWF(/%

#BMBODFE-JOF-FW

FM0VUQVUT

9-3(/%  °

+BDL5

JQ 3

JOH ° 

4MFFWF

(/%

-*/&065165

-*/&065165



#BM-JOF-FWFM0VUQVU

(/%  °

#BM-JOF-FW

FM0VUQVU

(/%  °

13&4*.6-"503065

13&4*.6-"5

03065

6OCBM-JOF-FWFM0VU

5JQ 4MFFWF(/%

$POOFDUUPBEEJUJPOBM

BNQMJGJFSPSFGGFDUT

6OCBM-JOF-FW

FM0VU

5JQ

 4MFFW

F(/%

$POOFDUUPBEEJUJPOBM

BNQMJGJFSPSFGGFDUT

Advertising