Scag Power Equipment STT - Manual (Page 34)

30
Section 7
* PROCEDURE: Remove grease cap, part number 481559. Remove plug, part number 482028-01, and install
standard grease zerk (p/n 48114-06). Apply grease to the fitting until new grease appears at the top of the caster
extension. Remove the grease zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number
47007, is recommended for use in the installation of the grease cap.
+ Compatible Greases: Mobilix #2 found at Mobil Service Stations
Timken Lithium Multi-Use #2 found at industrial shops
Shell Alvania #2 found at Shell Service Stations
Lidok EP #2 found at industrial shops
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
Break-In 8 40 100 200 500 Procedure Comments
(First 10)
X Apply grease to fittings See paragraph 7.2
X Check hardware for tightness
X Change engine oil filter See paragraph 7.4
X Check hydraulic oil level See paragraph 7.3
X Replace engine fuel filter See paragraph 7.5
X Drain hydraulic system and See paragraph 7.3
replace hydraulic oil Use SAE 20W50
Oil
X Replace hydraulic oil filter See paragraph 7.3
X Replace cutter deck gearbox lubricant See paragraph 7.11
X Change coolant (Kawasaki only) See paragraph 7.12
7.2 LUBRICATION - GREASE FITTING LUBRICATION CHART
(SEE FIGURE 7-1, PAGE 27)
LUBRICATION NO. OF
LOCATION INTERVAL LUBRICANT PLACES
1 Caster Wheel Pivot * 500 Hours/Yearly Chassis Grease 2
2 Caster Wheel Bearings 100 Hours/Monthly Chassis Grease 2
3 Brake Actuator 200 Hours/Monthly Chassis Grease 2
4 Cutter Deck Bellcranks 100 Hours/Bi-Weekly Chassis Grease 4
5 Cutter Deck Pusharms 100 Hours/Bi-Weekly Chassis Grease 2
6 PTO Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 1
7 Cutter Deck Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 3
8 Brake Handle 200 Hours/Monthly Chassis Grease 1
9 Cutter Deck Drive Shaft U-Joints 200 Hours/Monthly Chassis Grease 2
10 Cutter Deck Drive Shaft Slip Sleeve 40 Hours/Weekly Chassis Grease 1