Swim'n Play end deck - Manual (Page 8)

8
4b
IMPORTANT: ONLY HAND TIGHTEN SCREWS AT THIS TIME
Where the Posts fasten to the deck, attach Angle Support Bars.
The illustrations below indicate which of the Close-up illustrations at the bottom of this
page and at the top of the next page show the proper assembly procedure for each
location.
Where One Angle Support Bar attach to the Post use the ½” Sheet Metal Screws.
Where Two Angle Support Bars attach to the Post use the 1” Sheet Metal Screw.
Where the Angle Support Bars attach to the deck use the ½” Truss Head Screws and
Hex Nuts.
POST FOR LADDER
ATTACHES ON
EITHER SIDE
CLOSE-UP
#13
CLOSE-UP
#13
CLOSE-UP #13
CLOSE-UP #12
CLOSE-UP
#11
CLOSE-UP #10 CLOSE-UP #10
POOL
POST FOR LADDER
ATTACHES ON
EITHER SIDE
CLOSE-UP
#13
CLOSE-UP
#13 CLOSE-UP #13
CLOSE-UP #12
CLOSE-UP
#11
CLOSE-UP #10 CLOSE-UP #10
POOL
15’ END DECK
&
18’ END DECK
12’ END DECK
1” SHEET
METAL SCREW
1/4” x 20
HEX NUT
1/2” SHEET
METAL SCREW
1/4” x 20 x 1/2”
TRUSS HEAD SCREW
ANGLE
SUPPORT
BAR
DECK
CLOSE UP #10
DECK
ANGLE
SUPPORT
BAR
1” SHEET METAL
SCREW
CLOSE UP #11