Sony DVP-NS530 - Manual (Page 67)

C:\Documents and
Settings\PC28\Desktop\3080594131 DVP-
NS530GB\SOURCE\01GB12ADV4-CEK.fm master page=right
DVP-NS530/730P
3-080-594-13(1)
67
Se
ttin
gs and
Ad
justmen
ts
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, damaging your ears or speakers.
◆ DOLBY DIGITAL (DVD VIDEO/DVD-RW
only)
Selects the type of Dolby Digital signal.
◆ MPEG (DVD VIDEO/DVD-RW only)
Selects the type of MPEG audio signal.
◆ DTS (DVD VIDEO only)
Selects whether or not to output DTS signals.
Note
When you use the DIGITAL OUT (COAXIAL or
OPTICAL) jack to listen to MPEG audio signals
and set “MPEG” to MPEG in “AUDIO SETUP”, no
sound will come from your speakers if you select
one of the TVS mode.
D-PCM Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
“DOWNMIX” item in
“AUDIO SETUP” (page 66).
DOLBY
DIGITAL Select this when the player is
connected to an audio
component with a built-in
Dolby Digital decoder.
PCM Select this when the player is
connected to an audio
component without a built-in
MPEG decoder. If you play
MPEG audio sound tracks, the
player outputs stereo signals
via the DIGITAL OUT
(OPTICAL or COAXIAL)
jack.
MPEG Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
OFF Select this when the player is
connected to an audio
component without a built-in
DTS decoder.
ON Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
01GB01COV.book Page 67 Wednesday, April 27, 2005 11:37 AM