Sharp 25R S100 - Manual (Page 36)

36
1 2 3
4 5 6
7 8 9
0 100
POWER
TV DVD
VCR
MENU MUTE
PAUSE
FLASHBACK
DISPLAY INPUT
STOP REC
REW PLAY FF
CH/SKIP
VOL
—
CH
CH
VOL
+
ENTER
A B C D
PERSONAL PREFERENCE
CATV TV
DVD VCR
Operation of Remote Control (Continued)
L HOW TO IDENTIFY A VCR
The remote control may already be set to
operate your VCR. Try this initial check to see
if going on to the following “identify” section is
necessary.
(1) Slide CATV/DVD-TV/VCR switch to VCR.
(2) Point remote towards VCR and press DVD/
VCR POWER .
(3) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR
and no further steps are needed.
• If no, continue to the “identify” section.
L To Identify Your VCR – Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
VCR.
• First look up your VCR’s remote control code
number before going through the direct code
entry steps control.
• If this procedure does not identify your
accessory VCR, use the Search method of
identification (described in the next section).
(1) Slide CATV/DVD-TV/VCR switch to VCR.
(2) Press and hold down DISPLAY and CH DOWN
(9) on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing DISPLAY
and CH DOWN (9) , enter your VCR’s two-
digit remote control code number using
REMOTE KEYPAD (refer to list).
• The remote control is now ready to send
commands to your VCR.
Some brands have more than one remote
code listed, due to changes in the remote
codes from early to later model years, or due
to format differences (VHS/BETA). In such
cases, you may have to try more than one code
to find the code your VCR accepts.
Note:
Depending on the model, year produced,
brand, and type of VCR, some models may
not be compatible with the remote control.
L To Identify Your VCR – Search Method.
(1) Slide CATV/DVD-TV/VCR switch on the
remote to VCR.
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of
the VCR.
Point the remote towards the VCR.
Hold down
DISPLAY and CH UP (8) at the
same time. KEEP HOLDING THE BUTTONS
DOWN.
(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when the
VCR has been identified.
Release
DISPLAY and CH UP (8) as soon
as the channel numbers start to scan up.
The VCR’s remote control code number has
been identified, and the remote is ready to
operate the VCR.
DVD/VCR
POWER
DISPLAY
CHANNEL
UP (8)/
DOWN (9)
CATV/DVD-TV/VCR
REMOTE
KEYPAD
TV
POWER
35-39 25R-S100.p65e 19/1/01, 4:40 PM 36