Sharp 25R S100 - Manual (Page 38)

38
1 2 3
4 5 6
7 8 9
0 100
POWER
TV DVD
VCR
MENU MUTE
PAUSE
FLASHBACK
DISPLAY INPUT
STOP REC
REW PLAY FF
CH/SKIP
VOL
—
CH
CH
VOL
+
ENTER
A B C D
PERSONAL PREFERENCE
CATV TV
DVD VCR
Operation of Remote Control (Continued)
DVD/VCR
POWER
INPUT
CHANNEL
UP (8)/
DOWN (9)
CATV/DVD-
TV/VCR
REMOTE
KEYPAD
Denon
JVC
Magnavox
Marantz
Mitsubishi
Panasonic
Philips
Pioneer
Proscan
RCA
Samsung
Sharp
Sony
Toshiba
Yamaha
Zenith 02
09
04
04
06
02
04
08
03
03
07
01
05
04
02
04
DVD BRAND
REMOTE CONTROL
CODE NUMBER
L HOW TO IDENTIFY A DVD
The remote control may already be set to
operate your DVD. Try this initial check to see
if going on to the following “identify” section is
necessary.
(1) Slide CATV/DVD-TV/VCR switch to DVD.
(2) Point remote towards DVD and press DVD/
VCR POWER .
(3) Does the remote turn the DVD ON and OFF?
• If yes, the remote is ready to operate the DVD
and no further steps are needed.
• If no, continue to the “identify” section.
L To Identify Your DVD – Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
DVD.
• First look up your DVD’s remote control code
number before going through the direct code
entry steps control.
(1) Slide CATV/DVD-TV/VCR switch to DVD.
(2) Press and hold down INPUT and CH DOWN
(9) on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing INPUT and
CH DOWN (9) , enter your DVDs two-digit
remote control code number using REMOTE
KEYPAD (refer to list).
• The remote control is now ready to send
commands to your DVD.
Note:
Depending on the model, year produced,
brand, and type of DVD, some models may
not be compatible with the remote control.
TV
POWER
DISPLAY
35-39 25R-S100.p65e 19/1/01, 4:40 PM 38