Sony RDR-GX7 - Manual (Page 67)

67
Re-editing the “program” in the DV Edit List
Connecti
ng a Digital V
ideo C
a
mera or
Ot
her
Equi
pment
Notes
• The disc may not be recorded as programmed if the tape’s time code is
not sequential or there are blanks between the recordings on the tape.
In this case, follow the instructions of “Recording From Equipment
Connected to the LINE IN Jacks” (page 71).
• You cannot set a scene to be shorter than one second.
• The start and end point of a program may be different from what you
have set if the source DV/Digital8 format tape is in any of the
following conditions:
– Recording mode was changed during the recording.
– There is a blank space in the recorded portion.
• This function may not work with certain digital video cameras. In this
case, follow the instructions of “Recording From Equipment
Connected to the LINE IN Jacks” (page 71).
Re-editing the “program”
in the DV Edit List
Each time you dub a DV/Digital8 format tape, the start and stop
points of the selected scenes (called a “program”) are saved in a
DV Edit List. You can make additional changes to these
“programs” if they were created by One Touch Dub or Advanced
Program Edit on a DVD-RW (VR mode). You can reset, erase,
or change the order of the scenes and then dub the re-edited
program to a disc of your choice.
To use this function, you will do the following:
Be sure to use the original DV/Digital8 format tape and the
DVD-RW (VR mode) that corresponds to the program in the DV
Edit List.
m
m
m
The recorder will fast forward and rewind the tape automatically
and record the scenes to a disc of your choice.
a Follow steps 1 to 4 of “Preparing for recording
using the DV IN jack” (page 59), then press
SYSTEM MENU.
Be sure to use the original DV/Digital8 format tape
and the DVD-RW (VR mode) that corresponds to the
program in the DV Edit List.
Connect your digital video camera and prepare for editing
Select a program from the DV Edit List
Edit the program in the DV Edit List
Dub the selected scenes to a disc
< / M / m / , ,
ENTER
SYSTEM MENU
m / M
, continued