Sony RDR-GX7 - Manual (Page 71)

71
Recording From Equipment Connected to the LINE IN Jacks
Connecti
ng a Digital V
ideo C
a
mera or
Ot
her
Equi
pment
To change the name of a program
1
While the DV Edit List is displayed, press M/m to
select the program name you want to change, then
press ENTER.
2
Press M/m to select “Rename” from the sub-
menu, then press ENTER.
The display for entering the program name appears.
3
Enter a name by following the explanations on
page 18.
To erase a program
1
While the DV Edit List is displayed, press M/m to
select the program you want to erase, then press
ENTER.
2
Press M/m to select “Erase” from the sub-menu,
then press ENTER.
3
Press </, to select “OK,” then press ENTER.
z Hints
• You can preview the scenes within the program title by selecting
“Preview” in step 5.
• On a DVD-RW (VR mode), chapter marks are inserted at the start of
each scene and where the recordings start on the tape. For other discs,
the recorder marks chapters either in 6 or 15 minute intervals
depending on the setting in “Auto Chapter” in Features Setup
(page 79).
Notes
• If you want to play the disc on other DVD equipment, finalize the disc
(page 34).
• In order for a One Touch Dub recording to be added to the DV Edit
List, “Add to Edit List” in Features Setup must be set to “On”
(page 81).
• Copy dubbing may not work if you have edited sections that do not
contain any recorded material.
• This function may not work with certain digital video cameras. In this
case, follow the instructions of “Recording From Equipment
Connected to the LINE IN Jacks” (page 71).
Recording From Equipment
Connected to the LINE IN
Jacks
You can connect other equipment (e.g. a VCR or video camera),
and output the audio/video signals to the recorder for recording.
Use the DV IN jack on the front panel if the equipment has a DV
output jack (i.LINK jack) (page 59).
See also the instruction manual supplied with the connected
equipment.
◆If you cannot use the DV Edit functions
If your digital video camera has a DV jack but you cannot use
the DV Edit functions, follow the steps of “Recording from
connected equipment” below, and do the following:
– Connect your digital video camera to the DV IN jack on the front
panel.
– Select “DV” in step 4 below.
– Select “Stereo1,” “Mix,” or “Stereo2” from “DV Audio Input” in step
6 below.
Connecting other equipment to the
LINE 2 IN or LINE 4 IN jacks
You can monitor the recorded picture with a TV connected to the
recording equipment.
~ AC IN
LINE 2 OUT
S VIDEO VIDEO R-AUDIO-L
COMPONENT VIDEO OUT
CB
Y
CR
LINE 4 IN
S VIDEO VIDEO R-AUDIO-L
LINE 1 - TV AERIAL
IN
OUT
LINE 3/DECODER
DIGITAL OUT PCM/DTS/MPEG/ DOLBY DIGITAL
COAXIAL
OPTICAL
OUTPUT
S VIDEO AUDIO
L R
VIDEO
VCR, etc.
DVD recorder (front)
(rear)
Audio/video cord
(not supplied) S VIDEO
cord (not
supplied)
to LINE 2 IN
: Signal flow
to LINE 4 IN
VCR, etc.
, continued