Sunbeam WD5810 - Manual (Page 9)

• Select another section of
hair and repeat the process
until all the hair has been
straightened.
• Finish with a few drops of
D Frizz Smootheez Serum
from PPS.
• Switch off the appliance
and remove the plug from
the power outlet. Allow
to cool completely before
storing.
• Please note that your styler
can be used on dry hair.
Changing the temperature
settings
• When you plug in and
switch on, the styler will
automatically set at the
hottest setting of 200
degrees (setting 4).
• If you wish to use a
lower setting, push the
temperature control switch.
This will reduce the
temperature to 175 degrees
(setting 3).
• Pushing the switch again
will reduce the temperature
to 150 degrees (setting 2).
• Pushing the switch again
will reduce the temperature
further to 130 degrees
(setting 1).
• Pushing the switch again
will turn the unit off.
• To increase the temperature,
switch the unit back on.
• Allow 30 seconds for each
setting to reach the correct
temperature.
• We recommend that
you do not use a higher
temperature than necessary
to straighten your hair. Start
on a lower setting and move
up if required.
Note: You may hear a hissing
Using your Wet to Dry Straightener with
Ionic Technology continued
7