Star Micronics SP200F - Manual (Page 16)

– 13 –
ENGLISH
Fig. 4-16 Insertion of the paper into the auto cutter
(When using copying paper)
9 Pull on the edge of the paper to
remove any slack and then lower the
auto cutter.
0 Insert the paper through the paper
outlet and then replace the cover by
reversing the removal steps.
Note: When the paper end mark ap-
pears on the paper, replace the
roll paper before it runs out.
Fig. 4-18
Paper
outlet
Auto cutter
Fig. 4-17 Paper outlet of the front
cover
Paper insertion
slit
Platen
Lower paper
Upper
paper
Print head
Print head
Paper insertion
slit
Auto cutter
Platen
Lower paper
Upper paper
FEED switch