Star Micronics SP200F - Manual (Page 23)

– 20 –
ENGLISH
6-4. Control Codes Used for Peripheral Units
Control codes Hexadecimal codes Function
<ESC> <BEL> n1 n2 1B 07 n1 n2 Adjust drive pulse width for peripheral unit (Default
setting)
<BEL> 07 Deferred drive command “A” for peripheral unit 1
<FS> 1C Immediate drive command “B” for peripheral unit 1
6-5. Auto Cutter Control (SP240 type only)
Control codes Hexadecimal codes Function
<ESC> “d” “0” 1B 64 30 Full-cut command to the auto cutter
<ESC> “d” <0> 1B 64 00
<ESC> “d” “1” 1B 64 31 Partial-cut command to the auto cutter
<ESC> “d” <1> 1B 64 01
6-6. Other Control Codes
Control codes Hexadecimal codes Function
<CAN> 18 Cancel print data in buffer
<ESC> “@” 1B 40 Initialize printer
<ESC> “e” “0” 1B 65 30 ON LINE/FEED switch valid
<ESC> “e” <0> 1B 65 00 (Default setting)
<ESC> “e” “1” 1B 65 31 ON LINE/FEED switch invalid
<ESC> “e” <1> 1B 65 01
<ESC> “f” “0” 1B 66 30 ON LINE switch valid
<ESC> “f” <0> 1B 66 00 (Default setting)
<ESC> “f” “1” 1B 66 31 ON LINE switch invalid
<ESC> “f” <1> 1B 66 01