Sunbeam 3946 - Manual (Page 4)

7 6
SHOT OF STEAM ® Feature
• The SHOT OF STEAM ® feature provides an extra burst of steam for deep penetration
of stubborn wrinkles. The SHOT OF STEAM ® feature can be used with dry or steam
ironing provided the tank is at least 1/4 full of water and the temperature dial is set
within the steam band.
• Allow the iron to heat for approximately 2 minutes.
• Press the SHOT OF STEAM ® button several times to prime the pump.
• Pump the SHOT OF STEAM ® button another three to four times in order to clean the unit.
This feature is now ready for use. The SHOT OF STEAM ® feature can be used continuously
with just a short pause between shots. The SHOT OF STEAM ® feature is most effective
with the iron held in a horizontal position just above the fabric being ironed.
• If the tank runs dry, unplug the iron and refill with water. The iron may be filled with
water while it is hot. N OTE : It may be necessary to re-prime the pump before using
the SHOT OF STEAM ® feature again.
SPRAY MIST ® Feature
• Use the SPRAY MIST ® feature to dampen fabrics with stubborn wrinkles.
• Press the gray SPRAY MIST ® button firmly to produce spray.
SAFETY SMART ® Feature Auto Shut-Off
• When the iron is plugged into 120 volt AC electrical outlet, the steady red light signals
that the iron is powered in and is ready to be used.
• If the iron is left motionless in its upright position the iron will stop heating in 15 minutes.
The light on the handle will blink to indicate the iron has automatically
shut off and will continue blinking until the iron is restarted or unplugged.
• If the iron is left motionless in the ironing position or accidentally tipped over, the iron
will stop heating in 30 seconds. Again, the light on the handle will blink to
indicate the iron has automatically shut off and will continue blinking
until the iron is restarted or unplugged.
• N OTE : If the temperature dial is turned to the “O” position, light will continue blinking
and then go off.
• To restart the iron, move the iron back and forth. Allow the iron to heat and continue
ironing as normal.
• N OTE : Although heat is no longer generated once the iron has automatically shut off,
allow sufficient time for the iron to cool before touching the soleplate or storing
the iron.
Non-Stick Finish
• Non-Stick coating prevents sticking of fabrics and starch residue to the soleplate.
• To clean the soleplate, allow iron to cool and wipe with a soft cloth using a mild
vinegar solution.
• Do not use scouring pads, abrasives or chemical cleaning solvents as they may
damage the finish.
• N OTE : Scratches in the non-stick soleplate do not affect the performance of the iron.
Care After Each Use
• Turn the steam dial to .
• Unplug the iron from the power outlet.
• Empty the water tank by opening the water reservoir cover and turning the iron upside
down to allow water to flow from the opening. Shake the iron gently to remove trapped
water drops.
• Close cover and allow the iron to cool.
• When not ironing, always set steam dial .
C
A R E A N D
M
A I N T E N A N C E
Steam Valve
The steam valve (attached to the variable steam dial) is removable for easy cleaning of lint
and scale build up. Cleaning the steam valve is only necessary if you notice a reduction
in steam performance. To remove the steam valve; allow iron to cool, empty the water tank
and place iron on the soleplate. Turn the variable steam dial to CLEAN. The valve will
“pop-up” with a light pull. Pull up to remove the steam valve fully. Wipe the tip gently
with a damp cloth to clean. To replace, align CLEAN with the indicator mark.
Push down and rotate clockwise to
.
N OTE : Do not pour water into the steam valve hole.
Soleplate
If starch or other material clings to the iron’s soleplate, allow the iron to cool and wipe
with a soft, damp cloth. Avoid ironing over snaps, zippers, rivets, etc., as they may scratch
the soleplate.
Storage
Always store your iron on the heel rest. Empty water tank. Never store with the soleplate
facing down or in the carton. Always store your iron with the steam dial turned to
.