Sony TA-FE370 - Manual (Page 7)

7 GB
Getting Started
Speaker system hookups
Overview
Here you learn how to connect speakers to the
amplifier. Before connecting, remove the caps
from the speaker terminals.
What cords will I need?
Speaker cord (not supplied) (1 for each
speaker)
Twist the stripped ends of the cord about
15 mm. Be sure to match the speaker cord to
the appropriate terminal on the components: +
to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
(+)
(–)
(+)
(–)
]
}
]
}
b
IN RECOUT IN
PHONO
IN
TUNER
IN IN RECOUT IN
CD AUX TAPE2/MD TAPE1/DAT
EON CONTROL
AC OUTLET
SPEAKERS
L
R
IMPEDANCE USE 4 - 16 Ω
SWITCHED 100W MAX
+
–
+
–
R L
SIGNAL GND y
IN
SPEAKERS
IN RECOUT IN
PHONO
IN
TUNER
IN IN RECOUT IN
CD AUX TAPE2/MD TAPE1/DAT
EON CONTROL
AC OUTLET
SPEAKERS
L
R
IMPEDANCE USE 4 - 16 Ω
SWITCHED 100W MAX
+
–
+
–
R L
SIGNAL GND U
IN
Mains lead hookups
Connecting the mains lead
Connect the mains lead from this amplifier and
from your audio/video components to wall
outlets.
Tip
You can power other components through AC
OUTLET on the amplifier (except for U.K. model).
By connecting other audio components to AC
OUTLET on the amplifier, you can supply power to
the connected components through the amplifier and
turn them all on or off when you turn the amplifier on
or off.
Caution
Make sure that the total power consumption of all
components connected to the outlets on the amplifier
does not exceed 100 watts. Do not connect electrical
home appliances such as an electric iron, fan, TV, or
other high-wattage appliances to these outlets.
Note
Separate the mains lead, audio connecting cords and
speaker cords. Noise or sound deterioration may
occur when audio connecting cords are in contact
with the mains lead, or when the mains lead or
speaker cords are placed near the tuner’s loop aerial
or aerial wire.
To a wall outlet