Sharp AF-R55CX - Manual (Page 13)

13
HOW TO OPERATE
ENERGY SAVER
TO CHANGE AIR FLOW DIRECTION
Horizontal louvers
Adjust UP/DOWN air flow
The horizontal louvers are used to adjust the UP / DOWN direction of air flow, and the vertical
louvers are used to adjust the LEFT / RIGHT direction of air flow for uniform and efficient cooling
of the room.
During normal operation, the thermostat automatically controls cooling and the fan runs continu-
ously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and
the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after
the compressor stops. Even after the fan stops, the fan will rotate for 2 minutes, every maximum
20 minutes, to detect room temperature.)
2 To cancel, touch ENERGY SAVER
pad again.
• ENERGY SAVER indicator will go
off.
NOTE: ENERGY SAVER cannot be set during fan only (HIGH FAN, MED FAN, LOW FAN)
operation.
During cooling operation
1
Vertical louvers
Adjust LEFT/RIGHT air flow
Lever
Touch ENERGY SAVER pad.
• ENERGY SAVER indicator will light.
POWER
ON/OFF
F
hr
SELECTOR TIMER
ON/OFF
ENERGY
SAVER
COOL / FAN TEMP
ENERGY SAVER indicator
ENERGY SAVER pad