Installing the speakers on the wall, Ge tting star te d – Sony DAV-FX80 User Manual

Page 21

Advertising
background image

Ge
tting Star

te

d

21

US

After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to
check that all the speakers are connected correctly. For details on outputting a test tone, see page 83.
If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker
other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this
happens, check the speaker connection again.

• Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords

are reversed, the sound will lack bass and may be distorted.

Installing the speakers on the wall

1

Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.
See the illustrations below.

2

Fasten the screws to the wall.

The screws should protrude 7 to 8 mm (9/32 to 11/32 inch) for the front speakers, 8 to 9
mm (11/32 to 3/8 inch) for the surround speakers.

3

Peel the seals off the two screw points on the rear of the speaker.

(Front speakers only)

Note

25 mm (1 inch)

4 mm (

5

/

32

inch)

Hole on the back of
the speaker

4.6 mm
(

3

/

16

inch)

10 mm
(

13

/

32

inch)

7 to 8 mm
(

9

/

32

to

11

/

32

inch)

For the front speakers

8 to 9 mm
(

11

/

32

to

3

/

8

inch)

For the surround speakers

165 mm
(6

1

/

2

inch)

continued

Advertising
This manual is related to the following products: