Samsung DVD-P450 - Manual (Page 58)

ENG-58
C h a p t e r 6
R
E F E R E N C E
Firmware upgrade
Introduction
Samsung will often support the software upgrade to improve the performance of this unit to the latest
status, through Samsung Internet Site (www.samsung.com).
Because the specially new MPEG4 codec continues and it is appearing. What improvements are
made depends on the upgrade software you are using as well as the software that your DVD-player
contained before the upgrade.
How to make an upgrade disc
Write the downloaded file onto a blank CD-R or CD-RW disc, using the following settings:
Upgrade procedure
1
You have to download a new file
through Download Center of
Samsung Internet Site
(www.samsung.com).
2
Write the file to Disc using
CD-RW of your computer.
Note
- File System CD-ROM ISO Level
- Character set ISO 9660
- Finalized, single session
- Write speed low
1
Open the disc tray.
Place the disc on the tray.
Close the tray.
The Firmware upgrade
screen appears.
2
Press the œ œ/√ buttons to
select Total , then press the
ENTER button.
3
Press the number buttons
to select the desired
language.
▼
- In the middle of the writing, the tray will open
automatically. After taking out the disc,
please wait for about 2 minutes.
- If the unit was successfully updated, the unit
will turn off and on after closing the tray
automatically.
Note
- If the “Select Menu Language” doesn't appear,
please contact to “Samsung Service Center”.
- Do not press any button and unplug the power
code during upgrade.
- The upgrade procedure may change, refer to
the web site (www.samsung.com).
Firmware upgrade
appears on the display
Firmware upgrade starts ▼
When the unit turns on, this screen will display.
00708C_P450_XSS_eng_2 2/26/05 10:46 PM Page 58