Energy saver, To change air flow direction, Energy saver to change air flow direction – Sharp AFP80CX User Manual
Page 13: How to operate
13
POWER
ON/OFF
hr
F
SELECTOR
TIMER
ON/OFF
ENERGY
SAVER
COOL / FAN
TEMP
ENERGY SAVER indicator
ENERGY SAVER pad
HOW TO OPERATE
ENERGY SAVER
TO CHANGE AIR FLOW DIRECTION
Horizontal louvers
Adjust UP/DOWN air flow
The horizontal louvers are used to adjust the UP / DOWN direction of air flow, and the vertical
louvers are used to adjust the LEFT / RIGHT direction of air flow for uniform and efficient cooling
of the room.
During normal operation, the thermostat automatically controls cooling and the fan runs continu-
ously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and
the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after
the compressor stops. After the fan stops, the fan is programmed to rotate for approx. 2 minutes
to detect room temperature. This will occur within a 20 min time span.)
2
To cancel, touch ENERGY SAVER
pad again.
• ENERGY SAVER indicator will go
off.
NOTE: ENERGY SAVER cannot be set during fan only (HIGH FAN, MED FAN, LOW FAN)
operation.
During cooling operation
1
Vertical louvers
Adjust LEFT/RIGHT air flow
Lever
Touch ENERGY SAVER pad.
• ENERGY SAVER indicator will light.