Sony DAV-DZ260 - Manual (Page 52)

masterpage:Left
specdef v20070110
filename[E:\SS2008\Models\DSR2E\3283036112\3283036112_DAV-DZ260\gb06dsc.fm]
model name [DAV-DZ260]
[3-283-036-11(2)]
52 GB
[L/R] 3.0 m/10 ft 2)3) : Set the surround speaker
distance (up to 5.0 meters (16 ft) closer to the
front speakers).
1) 0.0 to 6.9 meters for North American models.
2) When you perform the Quick Setup (page 20), the
default settings are changed.
3) This item appears when you set [SURROUND] to
[YES] in the [CONNECTION] setting.
Note
• If all front and surround speakers are not placed at an
equal distance from your listening position, set the
distance according to the closest speaker.
• Do not place the surround speakers farther away from
your listening position than the front speakers.
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
x [LEVEL (FRONT)]
You can adjust the sound level of the front
speakers, center speaker, and subwoofer. Be
sure to set [TEST TONE] to [ON] for easy
adjustment.
[L/R] 0.0 dB: Set the front speaker level.
[CENTER] 0.0 dB
* : Set the center speaker
level.
[SUBWOOFER] +2.0 dB: Set the subwoofer
level.
* This item appears when you set [CENTER] to
[YES] in the [CONNECTION] setting.
x [LEVEL (SURROUND)]
You can adjust the sound level of the surround
speakers. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L/R] 0.0 dB * : Set the surround speaker level.
* This item appears when you set [SURROUND] to
[YES] in the [CONNECTION] setting.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
[OFF]: The test tone is not emitted from the
speakers.
[ON]: The test tone is emitted from each speaker
in sequence while adjusting level. When you
select one of the [SPEAKER SETUP] items, the
test tone is emitted from each speaker in
sequence.
Adjust the sound level as follows.
1
Set the [TEST TONE] to [ON].
2
Press C/X/x/c repeatedly to select the
desired speaker and the level.
3
Press .
4
Repeat Steps 1 to 3.
5
Press C/X/x/c repeatedly to set [TEST
TONE] to [OFF] after adjusting the
speaker level.
Note
• The test tone signals are not output from the HDMI
OUT jack.
Tip
• To adjust the volume of all the speakers at one time,
turn the VOLUME control on the unit, or press
VOLUME +/– on the remote.
• To return to the default setting when changing a
setting, select the item, then press CLEAR. Note that
only the [CONNECTION] setting does not return to
the default setting.
B