Sony CPD-100SFT - Manual (Page 5)

5
EN
Adjusting the Picture Centering
The adjustment data becomes the individual setting for each
input signal received.
1
Press the CENTER button.
The “CENTER” OSD appears.
2
For vertical adjustment
Press the > >/. buttons.
> . . . to move up
. . . . to move down
For holizontal adjustment
Press the ¨ ?// buttons.
? . . . to move left
/ . . . to move right
To erase the “CENTER” OSD, press the CENTER button again.
The “CENTER” OSD automatically disappears 10 seconds after
you release the buttons.
To reset, press the RESET button while the OSD is on.
Adjusting the Picture Brightness
The adjustment data becomes the common setting for all input
signals.
1
Press the ¨ ?// button.
The “CONTRAST/BRIGHTNESS” OSD appears.
2
Press the ¨ ?// buttons to adjust picture brightness.
? . . . for less brightness
/ . . . for more brightness
The “CONTRAST/BRIGHTNESS” OSD disappears 3 seconds
after you release the buttons.
To reset, press the RESET button while the OSD is on.
Adjusting the Picture Contrast
The adjustment data becomes the common setting for all input
signals.
1
Press the > >/. button.
The “CONTRAST/BRIGHTNESS” OSD appears.
2
Press the > >/. buttons to adjust picture contrast.
> . . . for more contrast
. . . . for less contrast
The “CONTRAST/BRIGHTNESS” OSD disappears 3 seconds
after you release the buttons.
To reset, press the RESET button while the OSD is on.
Adjustments
When one of the preset-type signals is input, no picture
adjustment is necessary.
You can, however, adjust the picture to your preferences by
following the procedure described below.
You can adjust the all items on the OSD (On Screen Display).
Control Panel
p Before adjusting the items, turn on the unit and feed the
video signal from the connected computer/work station.
p Adjustments will be stored automatically.
COLOR GEOM SIZE CENTER
POWER
SAVING
POWER RESET
CONTRAST/BRIGHTNESS
1 0 0 5 0
3 1 . 5 kHz/70Hz
Horizontal
frequency
∗
Vertical
frequency
∗
CONTRAST/BRIGHTNESS
1 0 0 5 0
3 1 . 5 kHz/70Hz
Horizontal
frequency
∗
Vertical
frequency
∗
CENTER
CENTER
3 2 6 8
∗
The horizontal and vertical frequencies for each input signal
received appear on the “CONTRAST/BRIGHTNESS”
OSD.