Sun Microsystems Sun Fire X4100 - Manual (Page 113)

Chapter 3 Maintaining the Sun Fire X4100 Server 3-53
FIGURE 3-46 Removing the GRASP Board
c. Raise the corner of the GRASP board until it is clear of the locking tab.
d. Pivot the front edge of the GRASP board upward to disengage it from the rear
plastic bracket and to disengage its connector from the motherboard.
8. Remove all DIMMs from the motherboard:
a. Rotate both DIMM slot ejectors outward as far as they will go. The DIMM is
partially ejected from the socket. See FIGURE 3-47 .
b. Carefully lift the DIMM straight up to remove it from the socket.