Sharp LL-T2000A - Manual (Page 10)

10
Connecting the monitor to a power source
Use only the AC adapter supplied.
Note:
-
Do not overly bend the cable or add extension
cords as this could lead to malfunction.
1. Remove the stand cover.
2. Remove the cover.
3. Connect the AC adapter to the monitor's power
terminal.
4. Replace cover.
(Rear View)
Stand cover
Cover
Place cord
on hook
AC adapter
Run cord
through hole.
Power terminal
Cover
Connecting the monitor and turning
the monitor on and off
Lift one side
5. Connect power cord to AC adapter.
6. Replace stand cover.
2
1 1
7. Place power plug into AC outlet.
Power cord
Fitting the AC adapter inside the stand
Place adapter
inside stand cavity.
Wind the cord
Stand cover