Smeg WDI12C - Manual (Page 6)

GB
6
3. INSTALLATION INSTRUCTIONS
Important !
The appliance must be installed by a specialised technician according to current regulations.
This washer dryer is very heavy. Take care when lifting it.
3.1 UNPACKING
The inside of the machine comprises a mov ing assembly which is blocked f or transport purposes by the screws
(A) located at the rear of the washer dryer.
1. Release the assembly by removing these screws with a 13 mm wrench.
2. Remov e the screws (A) and relative spacers (B) from the back of the washer dry er.
3. To prev ent water from entering the machine, or people f rom touching live components with their f ingers,
close the four holes left open by the screws with the supplied plastic plugs (C).
Attention!
• Do not turn the machine upside down and do not place it on its side.
• Keep all the components used to lock the drum assembly as they will be needed if you decide to move the
appliance in future.
3.2 POSITIONING AND L EV ELLING
1. Place the appliance in the
chosen position.
2. Caref ully lev el the machine in
all directions using a spirit
lev el and adjusting the f eet if
necessary. After adjusting the
machine, lock the feet with the
relativ e lock nuts.
The water inlet and drain hoses can be turned to the right or left depending on installation requirements.
Attention!
• Carry out this operation carefully to prevent the washer dryer from vibrating, generating noise or mov-
ing during operation.
• If the appliance is installed adjacent to a carpeted floor, ensure that the openings on its underside are
not obstructed.
• Make sure the washer dry er does not touch walls, furniture, etc., while it is working.