Sony CMT-EX1 - Manual (Page 8)

8
Step 3: Presetting radio stations
(continued)
To change the AM tuning
interval (except for European
model)
The AM tuning interval is factory-set to
9 kHz (10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first, then
turn off the power. While holding down the
TUNING + button, turn the power back on. When
you change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Tips
• When a new station is memorized, the station
formerly memorized at that preset number is erased.
• The preset stations are retained for a week even if
you disconnect the AC power cord or if a power
failure occurs.
• If noise is heard while listening to an FM station,
remove the FM antenna from the rear panel and
place the antenna outside the cabinet.
Saving the power in
standby mode
You can lower the power consumption to a
minimum (Power Saving Mode) and save energy
in the standby mode.
DISPLAY
, Press DISPLAY when the power is off.
The unit switches to the Power Saving Mode
and the clock display disappears.
The system turns on/off by pressing ?/1.
To cancel the Power Saving
Mode
Press DISPLAY.
The clock display appears.
Notes
• When the Daily Timer is set, you cannot switch to
the Power Saving Mode.
• When the Daily Timer is set in the Power Saving
Mode, the Power Saving Mode does not function
until the timer is canceled.