Sharp CP-BA150 - Manual (Page 16)

<P=002>
USING EXTERNAL UNITS
■
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1
Use a separately available RCA cord to connect the desired
external unit to the VIDEO/AUX jacks.
(red
→
right channel, white
→
left channel)
● When using video equipment (Laser Disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX button.
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2
- 4 of the "Recording from the built-in radio" section on page
13.
Note:
● To prevent hum interference, do not place this unit near a
television receiver.
■ Headphones
● Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
● Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
● When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
To the line output jack
RCA
cord
RESETTING THE MICROCOMPUTER
Reset the microcomputer under the following conditions:
● To erase all of the stored memory contents (clock and timer
settings, and tuner and CD presets).
● If the display is not correct.
● If the operation is not correct.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
While pressing down the 0 / R button and the X-BASS/DEMO
button, hold down the ON/STAND-BY button for at least 1
second.
● "CLEAR AL" will appear.
Caution:
● The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
TRANSPORTING THE UNIT
Before you move this product to a new location, proceed
as follows:
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
● Remove all CDs inserted in the unit.
4
Press the OPEN/CLOSE button to close the disc tray.
● Make sure that "NO DISC" is displayed.
5
Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power cord from the AC outlet.
CD
OPEN/
CLOSE
POWER
ON/
STAND-BY
X-BASS/
DEMO
POWER
ON/
STAND-BY
CD-BA150(SEC) TINSE0279AWZZ
15