Sunwave Tech. SRC-1600 User Manual
Page 12
SRC-1600 User’s Manual
8
Loading preset codes using auto search
You can quickly start using your SRC-1600 by
using the auto search to load preset codes.
1. Switch on the device for which you want to
set up the SRC-1600.
2. Select the appropriate device on the SRC-
1600 using the device buttons. See Selecting
devices and pages on page 7.
3. Press and hold
for two seconds to enter
setup on the touch screen.
4. Press
.
5. Point the IR transmitter of the
SRC-1600 at the device then
press
.
6. The SRC-1600 will try to turn off the device by
transmitting different preset IR codes. When
the device switches off, immediately press
any hard button or touch the screen.
7. Ensure that you have the correct code by
pressing Volume +/-, Channel +/- or to test.
If the code is not correct, press "
" or "
"
and test the code again.
8. Press the
button to save and exit.