Sanyo CE42WPX1 - Manual (Page 5)

5
Screen mode selector
To select the screen mode, Natural, Full
Zoom , Title-in, Normal.
Full, Normal when in PC mode. Refer to page 11
TV/AV button
To switch from TV, AV1,RGB, AV2, HDMI or PC mode
press repeatedly or
Press and hold in a few seconds, an AV
selectionbar appears. Select the mode you
require using the
Direct programme selector
For direct access to programmes
using (0-9) numeric buttons. For selection of
programme position 10 - 99, for example 23,
first press -/-- button and press 2 and 3
numeric buttons.
F/OK
To memorise channels
MENU
To enter and exit the main menus and sub menus.
Also see page 6
Picture mode selection
Press the button repeatedly to select the following
picture modes.
Personal - Personal preference mode.
Dynamic - Suitable for brightly lit rooms.
Standard - Normal viewing mode.
Eco - Suitable for dimly lit rooms and gives a
cinema - like effect.
Programme up and down
To select the next programme number or
previous programme number.
CS button
Press button to scan through all available channels
and back to the original channel.
Levels up/down
To adjust the menu levels .
Teletext/TV selector
To access this feature press the TXT/TV button the
picture changes from TV - TXT - MIX and back to TV.
Standby
To switch the monitor on and off. Also see page 6
Recall
To display the programme/ input information and
the Off timer if set.
You can also select colour systems in AV mode as follows
AUTO -> PAL -> SECAM -> NTSC3.58
Programme swap
To switch between current and previous
programme position watched.
Time display
In the TV mode if teletext is available
the teletext clock will be displayed on the
screen. Press again to cancel.
JXPLA
keys
Sound mute
To mute the sound from the speakers.
The sound changes as follows;
Normal volume -> Mute
Bass expander
To get an emphasised bass sound ON or OFF.
Surround mode selector
To select the surround mode, OFF, MID, MAX
56
REMOTE CONTROL REMOTE CONTROL GB GB
Step : 2 Remote control battery installation
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.