Sharp VC-MH715HM - Manual (Page 21)

17
www.sharp.co.uk/support
BASIC OPERATION
HOW TO CHECK, CHANGE AND CANCEL A DELAYED
RECORDING
Before you start!
• If the Timer Standby symbol appears on the VCR display,
press the TIMER ON/OFF button to remove the
symbol.
CHECKING A RECORDING
1. Press STOP to switch on the VCR.
2. Press the MENU button.
3. Press[ / ]to select TIMER . Press the
SET button to confirm.
• All the delayed recordings in the VCR’s memory
will be shown.
4. If the settings are correct press the MENU
button to exit.
• If you wish to change or cancel any settings,
follow the procedures below.
CHANGING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING above.
2. To change a delayed recording, press
[ / ] to highlight the recording, then press
the SET button to select.
3. Press [ / ] to highlight the setting to be
changed and correct it by using the[ / ]
or the NUMBER BUTTONS .
4. When all corrections are complete press the
SET button to confirm, then press the
MENU button to exit.
CANCELLING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING above.
2. To cancel a delayed recording, press
[ / ]to highlight the recording to be
cancelled, then press CLEAR .
3. Press the MENU button to exit.
NOTE:
• If there are some programmes to be recorded, do not forget to press TIMER ON/OFF
button to return the VCR to Timer Standby mode.
MENU SCREEN
T I ME R
MOD E
S E T U P
į Ĭ : S E L EC T
S E T : E N T E R ME NU : E X I T
SET
1 / 2
DA T E P R S T AR T S T OP
2 1 / 0 6 0 2 1 2 : 0 0 1 3 : 0 0 S P
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
SET
SET
1 / 2
DA T E P R S T AR T S T OP
2 1 / 0 6 0 2 1 2 : 0 0 1 3 : 0 0 S P
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
- - / - - - - - : - - - : - - - -
TINS-A079UMN1.book Page 17 Monday, November 4, 2002 1:01 PM