Savin 4700WD - Manual (Page 38)

User Tools (System Settings)
26
2
Key Operator Tools
If the access code function has been set, you cannot access the key operator func-
tion unless you enter the access code (up to 8 digits).
❖ ❖ ❖ ❖ Key Operator Access
The encrypted code used to access the management settings is called the ac-
cess code.
This setting specifies whether to use an access code (up to 8 digits) or not. You
can also store the access code when you use the management settings.
• Off
• On
Note
❒ Default: Off
❖ ❖ ❖ ❖ User Code Access
Specifies whether to use user codes to limit or monitor the count for the [Copier]
function.
❖ ❖ ❖ ❖ Key Counter Access
Specifies whether to use the optional key counter to manage the count for the
[Copier]
function.
❖ ❖ ❖ ❖ Set Key Card
Specifies whether to use the optional key card to manage the count for the
[Copier]
function.
❖ ❖ ❖ ❖ Auto Off Timer
After copying, or no other key operations are performed, the machine turns
itself off (apart from the main power switch) after a specified period. This is
called a Auto Off. This setting specifies the time interval before entering this
mode.
Note
❒ Default: 60 minutes
❒ The time can be set from 1 to 240 minutes.
❖ ❖ ❖ ❖ AOF (Keep It On.)
Makes the Auto Off Timer setting active. Leave this set to on.
For details about this function, contact your service representative.
• On
• Off
Note
❒ Default: On
DolphinGB-Syst-F_V4_FM.book Page 26 Wednesday, May 2, 2001 1:19 PM