Sharp R-190HK/HW - Manual (Page 11)

SEC R-190H
9
TINSEA975WRRZ-D32 SEC R-190H
START
MINUTE PLUS
START
MINUTE PLUS
TIMER
CLOCK
TIMER
CLOCK
When the defrost time is complete, a long
tone will sound and
will appear in
the display.
This is a 12 hour clock. If you attempt to enter an
incorrect clock time,
will appear in the
display. Touch STOP/CLEAR pad and re-enter the
time.
• If the electrical power supply to your microwave
oven should be interrupted, the display will inter-
mittently show
after the power is rein-
stated. If this occurs during cooking, the program
will be erased. The time of day will also be erased.
Simply touch STOP/CLEAR pad and reset the
clock for the correct time of day.
P R O C E D U R E D I S P L A Y
P R O C E D U R E D I S P L A Y
• Before operating your new microwave oven make
sure you read and understand this operation
manual completely.
• Before the oven can be used, follow these pro-
cedures:
1. Plug in the oven. Close the door. The oven dis-
play will then begin flashing .
2. Touch STOP/CLEAR pad.
will appear.
3. Touch CLOCK pad to set clock.
TO SET THE CLOCK
• Suppose you want to enter the correct time of
day 12:30 (A.M. or P.M.).
1 2 3 0
P R O C E D U R E D I S P L A Y
1
Touch CLOCK pad.
Enter the correct time of
day by touching the
numbers in sequence.
2
3
Touch CLOCK pad again.
STOP/CLEAR
Touch STOP/CLEAR pad to:
1. Erase if you make a mistake during program-
ming.
2. Cancel timer.
3. Stop the oven temporarily during cooking.
4. Return the time of day to the display.
5. Cancel a program during cooking, touch twice.
Your oven can be programmed for 99 minutes 99
seconds (99.99). Always enter the seconds after
the minutes, even if they are both zeros.
• Suppose you want to cook for 5 minutes at 100%.
TIME COOKING
1
Enter cooking time.
Touch START pad.
2
5 0 0
TO SET POWER LEVEL
There are eleven preset power levels.
Using lower power levels increases the cooking
time which is recommended for foods such as
cheese, milk and long slow cooking of meats. Con-
sult cookbook or recipes for specific recommen-
dations.
To lower the power, touch POWER LEVEL pad
once. Note the display will indicate “P-HI” (HIGH,
100%). To lower to “90%” touch POWER LEVEL
pad again. Repeat as necessary to select 80% -
0%.
The colon (:) will flash.
• Suppose you want to defrost for 5 minutes at
30%.
B E F O R E O P E R AT I N G
1 2 : 3 0
: 0
1 2 : 3 0
M A N U A L O P E R AT I O N
5 . 0 0
5 . 0 0
ON
1
Touch POWER LEVEL
pad 8 times or hold down un-
til the desired power level ap-
pears.
2
Enter defrost time.
3
Touch START pad.
4
P - 3 0
5 . 0 0
ON
5 . 0 0
5 0 0
88:88
:
88:88
EE
x 8
POWER
LEVEL
SEC R190H,P01-12/ 03.5.21, 7:57 PM 9