Sunbeam EM0480 - Manual (Page 9)

7
Operating your Café Series
™
Conical
Burr Coffee Grinder
Before using the coffee grinder, wipe the
base exterior with a damp cloth. Wash the
bean hopper, hopper lid and ground coffee
container in warm soapy water, then rinse
and dry.
Note: Do not immerse the burrs in water or
any other liquid.
Note: Do not place any parts of the coffee
grinder in the dishwasher.
1. Place the coffee grinder on a dry, level
surface.
2. To attach the bean hopper, position bean
hopper onto the top of the motor base,
push down and turn clockwise.
See figure 1.
3. Fill the bean hopper with coffee beans.
Tip: Remember to keep the hopper full at
all times. Having an even weight bearing
down on the burrs is important to ensure a
consistent grind.
Note: This coffee grinder is intended to grind
whole coffee beans only.
4. Place the hopper lid onto the bean hopper.
5. Plug the power cord into a 230-240V AC
power outlet and switch the power on.
6. Select the grind by turning the grind
adjustment collar to the desired setting,
see figure 2.
Refer to the grind setting table on page 9 to
assist you in selecting the correct grind level
for the desired brewing method.
For grinding continuous quantities
7. Remove the lid from the ground coffee
container and slide onto the preparation
mat. The coffee container will fit
comfortably into the domestic size group
handle locator, see figure 3.
Figure 1
Figure 2
Figure 3