Cradle configuration, Cradle configuration -23 – Symbol Technologies MC9000-K User Manual
Page 181
Communications
4-23
Cradle Configuration
The MobileDox Cradle Manager allows you to setup the Device IP Address and modify cradle
settings. See
Installing MobileDox Cradle Manager on page 4-16
for instructions to download and
install the software. To connect the cradle, see
Four Slot Ethernet Cradle on page 7-28
.
Setting the Device IP Address
By default, the cradle will use DHCP to obtain its IP address. However, if DHCP fails, the Cradle
Manager can assign an IP address.
This is used if the cradle is connected to the network, but fails to appear in
MobileDox. Enter the hardware device (MAC) address to locate the cradle
and assign it a new IP address.
1.
Launch the MobileDox Cradle Manager on your host computer.
2.
Click File - Set IP Address of Unlisted Device. The following screen appears:
Figure 4-20. MobileDox, Set IP Address of Unlisted Device Window
3.
Enter the appropriate MAC Address and IP address.
4.
Click OK.