Sound Performance Lab Gain Station 8 2383 - Manual (Page 9)

GainStation 8 9
Again, while the GainStation 8‘s housing is EMV-proof and
protects against HF-interference, placement of the unit is
very important since it amplifies microphone signals as well
as other unwanted signals. Thus, it is extremely important
that the external power supply not be positioned near the
GainStation 8.
IMPORTANT: Adjust the voltage setting on the back of the
external power supply so that it corresponds with the power
conditions. Before connecting the GainStation 8 or any other
equipment turn off all power.
The following graph shows the correct wiring for connecting
unbalanced signals to the balanced XLR connectors:
The Line Input connector is designed for unbalanced signals
only.
The TRS output connector (see „Analog Outputs“, page 10) can
be operated both with balanced and unbalanced wiring. Simply
use a mono 1/4" plug for unbalanced operation.
Rear panel/connections
General advices
Output
balanced unbalanced
1=GND
2 =
hot (+)
3 =
cold (-)
1 2
3
1 2
3
110 V – 120 V/ 60 Hz
220 V – 240 V/ 50 Hz:
1.6 A slow blow
110 V – 120 V/ 60 Hz:
3.2 A slow blow
VOLTAGE/FUSE FUSE RATING
220 V – 240 V/ 50 Hz