Sony CDP-XE270 - Manual (Page 14)

14
3
Press TIME EDIT to have the player
create the programme.
The display shows the tracks to be recorded.
“TAPE B” flashes in the display.
4
When you record on both sides of the
tape, press TIME EDIT again.
The player inserts a pause, then creates the
programme for side B. The display shows
the programmed tracks.
When you record on one side of the tape or
on a DAT or MD, skip this step.
5
Start recording on the deck and then
press
H on the player.
When you record on both sides of the tape,
the player pauses at the end of the
programme for side A.
6
Reverse the tape to side B and press
H or X on the player to resume
playing the remaining tracks.
To cancel Time Edit
Press PLAY MODE.
When using the remote, press CONTINUE.
Tips
• You can set the tape length freely using
l AMS L.
Example: When the tape length of one side is 30
minutes and 15 seconds
1 To set the minutes, turn l AMS
L until “30” appears in the display,
then pushl AMS L.
2 To set the seconds, turn l AMS
L until “15” appears in the display,
then pushl AMS L.
• To check and change your programme, see page 12.
Adjusting the Recording
Level (Peak Search)
The player locates the highest level among the
tracks to be recorded to let you adjust the
recording level before you start recording.
1
Before you start playing, press PEAK
SEARCH.
“PEAK” flashes in the display and the
player starts scanning the disc searching for
the highest peak level.
After scanning all the tracks, the player
repeats the portion with the highest peak
level.
2
Adjust the recording level on the deck.
3
Press x on the player to stop Peak
Search.
“PEAK” disappears from the display.
Note
The portion with the highest level may differ every
time you try the adjustment on the same disc. The
difference is, however, so slight that you won’t find
any problem in adjusting the recording level
precisely.
Recording a CD by Specifying Tape
Length (Time Edit) (continued)