Sony 3-288-523-13(1) - Manual (Page 8)

8
b Notes
• You cannot charge the battery pack while the
QUICK ON lamp is flashing. When the QUICK
ON lamp is flashing, press POWER to turn off
your camcorder. Make sure the QUICK ON
lamp is not flashing before charging the battery
pack.
To remove the battery pack
Turn off your camcorder and open the
battery/Memory Stick Duo cover.
Slide the battery eject lever.
Be sure not to drop the battery pack.
b Notes
• When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
(Movie) lamp/ (Still) lamp (p. 10)/
access lamp (p. 12)/QUICK ON lamp are turned
off.
To charge the battery pack using only
the AC Adaptor
Close the LCD panel with your camcorder
turns off, then connect the AC Adaptor to
the DC IN jack on your camcorder.
Charging time:
Approximate time (min.) required when
you fully charge a completely exhausted
battery pack.
Recording/Playback time:
Approximate time (min.) available when
you use a fully charged battery pack.
“HD” stands for high definition image
quality, and “SD” stands for standard image
quality.
(Unit:min.)
Battery eject lever
Available running time for the
supplied battery pack
HD SD
Charging time 135
Recording time* 1 * 2
Continuous recording
time
100 120
Typical recording
time*
3
50 60
Playback time* 2 135 145
* 1 [REC MODE]: SP
* 2 When the LCD backlight is on.
* 3 Typical recording time shows the time when
you repeat recording start/stop, turning the
power on/off and zooming.
DC IN jack
Open the jack cover.
DC plug
With the v mark
on the bottom