Sony CPD-G220R - Manual (Page 11)

11
US
Additional settings (OPTION)
You can manually degauss (demagnetize) the monitor, adjust the
moire cancellation level, reset to factory setting, and lock the
controls.
1 Press the MENU/OK button.
The main MENU appears on the screen.
2 Move the joystick m / M to highlight OPTION and
press the MENU/OK button.
The OPTION menu appears on the screen.
3 Move the joystick m / M to select the desired
adjustment item.
Adjust the selected item according to the following
instructions.
Degaussing the screen
The monitor is automatically demagnetized (degaussed) when the
power is turned on.
To manually degauss the monitor, first move the
joystick
m / M to select (DEGAUSS). Then move the
joystick , .
The screen is degaussed for about 5 seconds. If a second degauss
cycle is needed, allow a minimum interval of 20 minutes for the
best result.
Adjusting the moire*
If elliptical or wavy patterns appear on the screen, adjust the
moire cancellation level.
To adjust the amount of moire cancellation, first move
the joystick
m / M to select (MOIRE ADJUST). Then
move the joystick < / , until the moire effect is at a
minimum.
* Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.
Resetting the adjustments
The RESET option erases your customized setting.
To restore your monitor to the factory setting, first
move the joystick
m / M to select
0
(RESET). Then
move the joystick , , to reset the adjustment for
current input signal. Hold the joystick , for 2 seconds
to reset the adjustment for all input signals.
Note
When “reset the adjustment for all input signal” is activated, the
customized language selection goes back to the default language of
English.
Locking the controls
To protect adjustment data by locking the controls, first
move the joystick
m / M to select (CONTROL LOCK).
Then move the joystick , , to select ON.
Only the 1 (power) switch, EXIT, and (CONTROL LOCK)
of the OPTION menu will operate. If any other items are
selected, the mark appears on the screen.
To cancel the control lock
Repeat the procedure above and set (CONTROL LOCK) to OFF.
Example of moire