Sharp XG-C50X - Manual (Page 59)

Easy to Use Functions
-57
Displaying Dual Pictures ( Pict in Pict )
Picture in Picture function allows you to display two pictures on the same screen. You can
display the image input from INPUT 3 or 4 as an inset picture overlapping the main picture
from INPUT 1 or 2.
Displaying the Inset Picture
1
Press .
2
Press or on the remote
control or on the projector
to switch the image in the in-
set picture .
3
Press
' ' ' ' ', " " " " ", \ \ \ \ \ and | | | | | to set the
position of the inset picture.
• Press to stop the frame from mov-
ing or to make the frame disappear.
4
Press to move the inset pic-
ture.
• The inset picture will be moved to the
inset picture frame.
Note
• The inset picture can only be displayed
with composite video (NTSC/PAL/
SECAM) or S-Video signal.
• The Freeze function works only with the
inset picture, when the Pict in Pict mode
is in operation.
When the signal entered into INPUT 1 or 2
is as follows, Pict in Pict does not work:
• With a resolution that exceeds SXGA.
• When the input signal is 480 I , 480P,
540P, 580 I, 580P, 720P, 1035 I or 1080 I .
• When the input signal has changed to
the Interlace mode using RGB signals.
• When the picture display mode is set to
“DOT BY DOT”.
• When no signals are sent to INPUT 1 or
2, or when the resolution or refresh rate
(vertical frequency) is changed.
' , " , \ , | buttons
PinP button
INPUT 3/4 buttons
UNDO button
ENTER button