Sanyo DWM-3500 - Manual (Page 63)

-E62-
Manual presetting
1. Press [AM/FM] to select FM or AM.
2. Tune in the station to be preset as described in “Automatic/
Manual Tuning”.
3. Press [SETUP/MENU].
“Preset number” blinks.
4. While “preset number” is blinking, press [PRESET] + or – to
select the channel to be preset.
•
The number buttons on the remote control can also be
used.
• In this example, the channel is “9”.
5. While “preset number” is blinking, press [ENTER].
“Preset number” blinking stops.
6. Press [SETUP/MENU].
“Preset number” disappears.
•
In this example, “103.1 MHz” FM station is preset on FM
channel 9.
7. Repeat steps above to add more preset stations.
• When presetting a new station, the previous preset station
is cleared.
Listening to Preset Stations
1. Press [AM/FM] to select FM or AM.
2. Press [PRESET] + or – briefly to select the desired channel.
• If using the number buttons, press the number button(s),
then press [ENTER].
Example:
To select preset number 3, press [0] [3], then [ENTER].
To select preset number 12, press [1] [2], then [ENTER].
Note:
Usually, when receiving the FM stereo broadcast you enjoy FM
stereo sound, if the signal from the station becomes weak, the
tuner automatically sets to monaural reception.
5
4
Number
buttons
3, 6
1
ENTER
1
2
Number
buttons
VIDEO IN L-AUDIO IN-R
POWER
VOLUME EJECT REC CHANNEL AM/FM VCR/DVD PRESET + - OPEN/CLOSE
STOP PLAY
AM/FM PRESET +/–
2B80201A [E] P50-BACK 24/2/03, 7:16 PM 62