Sony DVP-M35 - Manual (Page 32)

32 EN
Playing Discs in Various Modes
You can
Turn on or off the TV
Select the input source for the TV
Swiches the wide mode of the TV
Adjust the volume of the TV
Change the channel of the TV
Controlling the TV or the AV
Amplifier (Receiver) with the
Supplied Remote
Z
If you adjust the remote signal, you can control your
TVs with the supplied remote. Default setting is to
control Sony TVs with the g mark.
When you connect the player to a Sony amplifier, you
can also set the input of the amplifier to this player
with the supplied remote .
Controlling TVs with the remote
Hold down POWER, and enter your TV’s
manufacturer’s code in the table below using the
number buttons. Then release POWER.
Code numbers of controllable TVs
If more than one code number is listed, try entering
them one at a time until you find the one that works
with your TV.
Notes
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote commander,
the code number automatically resets to 01 (Sony). Reset the
appropriate code number.
TV/VIDEO
CH
VOL
WIDE MODE
You can control your TV using the buttons below.
By pressing
TV POWER
TV/VIDEO
WIDE MODE
VOL
CH
Note
Depending on the TV, you may not be able to control your TV
or to use some buttons above.
POWER
Number
buttons
Manufacturer
Sharp
Aiwa
JVC
Toshiba
Siemens
Thomson
Loewe
Orion
Ferguson
NEC
TEAC
Akai
Nokia
Manufacturer
Sony (default)
Gold Star
Philips
Miver
Blaupunkt
Grundig
Saba
Panasonic
Samsung
Hitachi
Sanyo
Pioneer
Mitsubishi
Code
number
01
03, 04
06, 08
09
10, 21
11
12, 13
17, 49
23
24
25
26
27, 28, 50
Code
number
29
32
33
38
39
43
45
47, 48
52
66
67
68
69
TV/POWER
1 2 3
4 5 6
7 8 9
0
1 2 3
4 5 6
7 8 9
0