Kenwood KDC-W311 - Manual (Page 25)

English | 25
⁄
• Texts displayed using Russian characters are as follows.
- Folder name/ File name/ Song title/ Artist name/
Album name
- CD text (internal CD source)
• Texts cannot distinguish upper case and lower case in
Russian characters.
In Standby mode
Built-in Auxiliary input Setting
Set the Built-in Auxiliary Input function.
Display Setting
"AUX OFF" When selecting the source there’s no Auxiliary Input.
"AUX ON1" When selecting the source there’s Auxiliary Input.
"AUX ON2" When the unit is turned on by AUX source, the attenuator
function is activated. Press [ATT] button to cancel the
attenuator function in order to listen to the external
equipment. there’s Auxiliary Input.
⁄
• Setting to "AUX ON2" will not output the noise which is
produced when an external equipment is not connected
to the AUX terminal.
In Standby mode
Power OFF Timer
Setting the timer to turn this unit’s power OFF
automatically when Standby mode continues.
Using this setting can save the vehicle’s battery
power.
Display Setting
"OFF – – –" Power OFF Timer function is OFF.
"OFF 20M"
(Original setting) Turns the power OFF after 20 minutes.
"OFF 40M" Turns the power OFF after 40 minutes.
"OFF 60M" Turns the power OFF after 60 minutes.
In Standby mode
CD Read Setting
When there is a problem with playing a CD with
special format, this setting plays the CD by force.
Display Setting
"CD READ1" Play CD and Audio file.
"CD READ2" Play CD by force.
⁄
• Some music CDs may not play even in the "CD READ2"
mode.
In Standby mode
Demonstration mode Setting
Sets the demonstration mode.
1 Select the Demonstration mode
Push the Control knob towards [FM] or [AM].
Select the "DEMO" display.
2 Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO ON" The Demonstration mode function is ON.
"DEMO OFF" Exit Demonstration mode (Normal mode).